Change pg_bsd_indent to follow upstream rules for placement of comments
to the right of code, and remove pgindent hack that caused comments
following #endif to not obey the general rule.
Commit e3860ffa4d wasn't actually using
the published version of pg_bsd_indent, but a hacked-up version that
tried to minimize the amount of movement of comments to the right of
code. The situation of interest is where such a comment has to be
moved to the right of its default placement at column 33 because there's
code there. BSD indent has always moved right in units of tab stops
in such cases --- but in the previous incarnation, indent was working
in 8-space tab stops, while now it knows we use 4-space tabs. So the
net result is that in about half the cases, such comments are placed
one tab stop left of before. This is better all around: it leaves
more room on the line for comment text, and it means that in such
cases the comment uniformly starts at the next 4-space tab stop after
the code, rather than sometimes one and sometimes two tabs after.
Also, ensure that comments following #endif are indented the same
as comments following other preprocessor commands such as #else.
That inconsistency turns out to have been self-inflicted damage
from a poorly-thought-through post-indent "fixup" in pgindent.
This patch is much less interesting than the first round of indent
changes, but also bulkier, so I thought it best to separate the effects.
Discussion: https://postgr.es/m/E1dAmxK-0006EE-1r@gemulon.postgresql.org
Discussion: https://postgr.es/m/30527.1495162840@sss.pgh.pa.us
While the SQL standard is pretty vague on the overall topic of operator
precedence (because it never presents a unified BNF for all expressions),
it does seem reasonable to conclude from the spec for <boolean value
expression> that OR has the lowest precedence, then AND, then NOT, then IS
tests, then the six standard comparison operators, then everything else
(since any non-boolean operator in a WHERE clause would need to be an
argument of one of these).
We were only sort of on board with that: most notably, while "<" ">" and
"=" had properly low precedence, "<=" ">=" and "<>" were treated as generic
operators and so had significantly higher precedence. And "IS" tests were
even higher precedence than those, which is very clearly wrong per spec.
Another problem was that "foo NOT SOMETHING bar" constructs, such as
"x NOT LIKE y", were treated inconsistently because of a bison
implementation artifact: they had the documented precedence with respect
to operators to their right, but behaved like NOT (i.e., very low priority)
with respect to operators to their left.
Fixing the precedence issues is just a small matter of rearranging the
precedence declarations in gram.y, except for the NOT problem, which
requires adding an additional lookahead case in base_yylex() so that we
can attach a different token precedence to NOT LIKE and allied two-word
operators.
The bulk of this patch is not the bug fix per se, but adding logic to
parse_expr.c to allow giving warnings if an expression has changed meaning
because of these precedence changes. These warnings are off by default
and are enabled by the new GUC operator_precedence_warning. It's believed
that very few applications will be affected by these changes, but it was
agreed that a warning mechanism is essential to help debug any that are.
Formerly we relied on checking after-the-fact to see if an expression
contained aggregates, window functions, or sub-selects when it shouldn't.
This is grotty, easily forgotten (indeed, we had forgotten to teach
DefineIndex about rejecting window functions), and none too efficient
since it requires extra traversals of the parse tree. To improve matters,
define an enum type that classifies all SQL sub-expressions, store it in
ParseState to show what kind of expression we are currently parsing, and
make transformAggregateCall, transformWindowFuncCall, and transformSubLink
check the expression type and throw error if the type indicates the
construct is disallowed. This allows removal of a large number of ad-hoc
checks scattered around the code base. The enum type is sufficiently
fine-grained that we can still produce error messages of at least the
same specificity as before.
Bringing these error checks together revealed that we'd been none too
consistent about phrasing of the error messages, so standardize the wording
a bit.
Also, rewrite checking of aggregate arguments so that it requires only one
traversal of the arguments, rather than up to three as before.
In passing, clean up some more comments left over from add_missing_from
support, and annotate some tests that I think are dead code now that that's
gone. (I didn't risk actually removing said dead code, though.)
into nodes/nodeFuncs, so as to reduce wanton cross-subsystem #includes inside
the backend. There's probably more that should be done along this line,
but this is a start anyway.
is measured in kilobytes and checked against actual physical execution
stack depth, as per my proposal of 30-Dec. This gives us a fairly
bulletproof defense against crashing due to runaway recursive functions.
make VALUE a non-reserved word again, use less invasive method of passing
ConstraintTestValue into transformExpr, fix problems with nested constraint
testing, do correct thing with NULL result from a constraint expression,
remove memory leak. Domain checks still need much more work if we are going
to allow ALTER DOMAIN, however.
the parsetree representation. As yet we don't *do* anything with schema
names, just drop 'em on the floor; but you can enter schema-compatible
command syntax, and there's even a primitive CREATE SCHEMA command.
No doc updates yet, except to note that you can now extract a field
from a function-returning-row's result with (foo(...)).fieldname.
took some rejiggering of typename and ACL parsing, as well as moving
parse_analyze call out of parser(). Restructure postgres.c processing
so that parse analysis and rewrite are skipped when in abort-transaction
state. Only COMMIT and ABORT statements will be processed beyond the raw
parser() phase. This addresses problem of parser failing with database access
errors while in aborted state (see pghackers discussions around 7/28/00).
Also fix some bugs with COMMIT/ABORT statements appearing in the middle of
a single query input string.
Function, operator, and aggregate arguments/results can now use full
TypeName production, in particular foo[] for array types.
DROP OPERATOR and COMMENT ON OPERATOR were broken for unary operators.
Allow CREATE AGGREGATE to accept unquoted numeric constants for initcond.
such as bpchar(char_expression, N), and pull out the attrtypmod that
the function is coercing to. This allows correct deduction of the
column type in examples such as
CREATE VIEW v AS SELECT f1::char(8) FROM tbl;
Formerly we labeled v's column as char-of-unknown-length not char(8).
Also, this change causes the parser not to insert a redundant length
coercion function if the user has explicitly casted an INSERT or UPDATE
expression to the right length.
of the SELECT part of the statement is just like a plain SELECT. All
INSERT-specific processing happens after the SELECT parsing is done.
This eliminates many problems, e.g. INSERT ... SELECT ... GROUP BY using
the wrong column labels. Ensure that DEFAULT clauses are coerced to
the target column type, whether or not stored clause produces the right
type. Substantial cleanup of parser's array support.
varchar length.
Cleans up code so attlen is always length.
Removed varchar() hack added earlier.
Will fix bug in selecting varchar() fields, and varchar() can be
variable length.
Bruce Momjian